[2022] Use Valid Exam NSE5_FAZ-6.2 by Dumpleader Books For Free Website [Q30-Q50] : IT certification exam materials : http://blog.dumpleader.com

QUESTION 30
On the RAID management page, the disk status is listed as
What does the status Initializing indicate about what the FortiAnalyzer is currently doing?

FortiAnalyzer is ensuring that the parity data of a redundant drive is valid

FortiAnalyzer is writing data to a newly added hard drive to restore it to an optimal state

FortiAnalyzer is writing to all of its hard drives to make the array fault tolerant

FortiAnalyzer is functioning normally

QUESTION 31
What are two advantages of setting up fabric ADOM? (Choose two.)

It can be used for fast data processing and log correlation

It can be used to facilitate communication between devices in same Security Fabric

It can include all Fortinet devices that are part of the same Security Fabric

It can include only FortiGate devices that are part of the same Security Fabric

QUESTION 32
On FortiAnalyzer, what is a wildcard administrator account?

An account that permits access to members of an LDAP group

An account that allows guest access with read-only privileges

An account that requires two-factor authentication

An account that validates against any user account on a FortiAuthenticator

QUESTION 33
In order for FortiAnalyzer to collect logs from a FortiGate device, what configuration is required? (Choose two.)

Remote logging must be enabled on FortiGate

Log encryption must be enabled

ADOMs must be enabled

FortiGate must be registered with FortiAnalyzer

QUESTION 34
What is the recommended method of expanding disk space on a FortiAnalyzer VM?

From the VM host manager, add an additional virtual disk and use the #execute lvm extend <disk number> command to expand the storage

From the VM host manager, expand the size of the existing virtual disk

From the VM host manager, expand the size of the existing virtual disk and use the # execute format disk command to reformat the disk

From the VM host manager, add an additional virtual disk and rebuild your RAID array

QUESTION 35
What statements are true regarding disk log quota? (Choose two)

The FortiAnalyzer stops logging once the disk log quota is met.

The FortiAnalyzer automatically sets the disk log quota based on the device.

The FortiAnalyzer can overwrite the oldest logs or stop logging once the disk log quota is met.

The FortiAnalyzer disk log quota is configurable, but has a minimum o 100mb a maximum based on the reserved system space.

QUESTION 36
Refer to the exhibit.

What does the 1000MB maximum for disk utilization refer to?

The disk quota for each device in the ADOM

The disk quota for all devices in the ADOM

The disk quota for the FortiAnalyzer model

The disk quota for the ADOM type

QUESTION 37
In order for FortiAnalyzer to collect logs from a FortiGate device, what configuration is required? (Choose two.)

Remote logging must be enabled on FortiGate

Log encryption must be enabled

ADOMs must be enabled

FortiGate must be registered with FortiAnalyzer

QUESTION 38
How does FortiAnalyzer retrieve specific log data from the database?

SQL FROM statement

SQL GET statement

SQL SELECT statement

SQL EXTRACT statement

QUESTION 39
Which two statements about log forwarding are true? (Choose two.)

Forwarded logs cannot be filtered to match specific criteria.

Logs are forwarded in real-time only.

The client retains a local copy of the logs after forwarding.

You can use aggregation mode only with another FortiAnalyzer.

QUESTION 40
You are using RAID with a FortiAnalyzer that supports software RAID, and one of the hard disks on FortiAnalyzer has failed.
What is the recommended method to replace the disk?

Shut down FortiAnalyzer and then replace the disk

Downgrade your RAID level, replace the disk, and then upgrade your RAID level

Clear all RAID alarms and replace the disk while FortiAnalyzer is still running

Perform a hot swap

QUESTION 41
FortiAnalyzer uses the Optimized Fabric Transfer Protocok (OFTP) over SSL for what purpose?

To upload logs to an SFTP server

To prevent log modification during backup

To send an identical set of logs to a second logging server

To encrypt log communication between devices

QUESTION 42
FortiAnalyzer uses the Optimized Fabric Transfer Protocol (OFTP) over SSL for which purpose?

To send an identical set of logs to a second logging server

To encrypt log communication between devices

To upload logs to an SFTP server

To prevent log modification during backup

QUESTION 43
Logs are being deleted from one of the ADOMs earlier than the configured setting for archiving in the data policy.
What is the most likely problem?

CPU resources are too high

Logs in that ADOM are being forwarded, in real-time, to another FortiAnalyzer device

The total disk space is insufficient and you need to add other disk

The ADOM disk quota is set too low, based on log rates

QUESTION 44
Which statements are true regarding securing communications between FortiAnalyzer and FortiGate with IPsec? (Choose two.)

Must configure the FortiAnalyzer end of the tunnel only–the FortiGate end is auto-negotiated.

Must establish an IPsec tunnel ID and pre-shared key.

IPsec cannot be enabled if SSL is enabled as well.

IPsec is only enabled through the CLI on FortiAnalyzer.

QUESTION 45
Which two of the following must you configure on FortiAnalyzer to email a FortiAnalyzer report externally?
(Choose two.)

Mail server

Output profile

SFTP server

Report scheduling

QUESTION 46
What is the purpose of a predefined template on the FortiAnalyzer?

It can be edited and modified as required

It specifies the report layout which contains predefined texts, charts, and macros

It specifies report settings which contains time period, device selection, and schedule

It contains predefined data to generate mock reports

QUESTION 47
On the RAID management page, the disk status is listed as Initializing.
What does the status Initializing indicate about what the FortiAnalyzer is currently doing?

FortiAnalyzer is ensuring that the parity data of a redundant drive is valid

FortiAnalyzer is writing data to a newly added hard drive to restore it to an optimal state

FortiAnalyzer is writing to all of its hard drives to make the array fault tolerant

FortiAnalyzer is functioning normally

QUESTION 48
What is the purpose of the following CLI command?

To add a log file checksum

To add the MD’s hash value and authentication code

To add a unique tag to each log to prove that it came from this FortiAnalyzer

To encrypt log communications

QUESTION 49
Which two statements about log forwarding are true? (Choose two.)

Forwarded logs cannot be filtered to match specific criteria.

Logs are forwarded in real-time only.

The client retains a local copy of the logs after forwarding.

You can use aggregation mode only with another FortiAnalyzer.

QUESTION 50
What can the CLI command # diagnose test application oftpd 3 help you to determine?

What devices and IP addresses are connecting to FortiAnalyzer

What logs, if any, are reaching FortiAnalyzer

What ADOMs are enabled and configured

What devices are registered and unregistered

[2022] Use Valid Exam NSE5_FAZ-6.2 by Dumpleader Books For Free Website [Q30-Q50]

The benefit of obtaining the Fortinet NSE 5 - FortiAnalyzer (NSE5 FAZ-6.2) Exam Certification

Average Salary of Fortinet NSE 5 - FortiAnalyzer (NSE5 FAZ-6.2) Exam Certified Professional