NO.61 Refer to the exhibit.

Which template is used when a vHBA template pair is created for a specific server that inherits its attributes from an existing template?

NO.62 Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.

NO.63 An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations.
Which two features must be used to prevent these situations from happening in the future? (Choose two.)

NO.64 Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used.

NO.65 What are two reasons to select OTV as the DCI solution to connect multisite topologies? (Choose two.)

NO.66 Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.

NO.67 Which two configurations are available by using a service profile template in Cisco UCS Manager? (Choose two.)

NO.68 Which factor determines the choice of platform designing a Cisco HyperFlex infrastructure to support computer-aided design applications?

NO.69 A Cisco UCS instance has four interfaces on a UCS VIC. Where on the fabric interconnect does each interface terminate?

NO.70 What is an advantage of Cisco HyperFlex Edge as compared to Cisco HyperFlex Standard Clusters?

NO.71 An end user is experiencing network latency when accessing a database in a disaster recovery site. The monitoring team concluded that the database was writing simultaneously to the storage arrays on the primary and disaster recovery sites.
Which design resolves this issue?

NO.72 A cloud provider deploys an infrastructure based on Cisco ACI Fabric, Cisco UCS, and Cisco HyperFlex Data Platform. The storage area network will be based on Cisco MDS 9000 Series Switches with Hyper-V, VMware, and KVM used as the virtualization platform. The requirement is to deploy the overall solution by using a robust automation and orchestration tool.
Which tool meets these requirements?

NO.73 Which two configurations are available by using a service profile template in Cisco UCS Manager? (Choose two.)

NO.74 Refer to the exhibit.

A high-availability setup for iSCSI is designed with the host running iSCSI multipath software. Each IP storage port on the MDS switch exports the same two Fibre Channel target ports with different iSCSI target names.
In this design, how many iSCSI sessions are created from the host so that recovery occurs if any component fails?

NO.75 Drag and drop the configurations from the left onto the correct policies on the right.

NO.76 A network architect proposes a distinct Fibre Channel fabric to be used for a Cisco UCS blade server that hosts critical applications. Which action should be implemented for the fibre Channel traffic from the vHBA of this service to pass through the I/O module in the Cisco chassis to a specified uplink Fibre Channel port?

NO.77 A customer connects a high-speed Fibre Channel storage array to a Cisco MDS 9000 Series Switch using an 8 Gbps interface.
Which action guarantees line rate traffic processing on the interface?

NO.78 Refer to the exhibit.

Which template is used when a vHBA template pair is created for a specific server that inherits its attributes from an existing template?

NO.79 Drag the requirements from the left onto the correct policy types on the right.