[UPDATED 2022] DES-DD33 dumps Free Test Engine Verified By Certified Experts [Q14-Q37]

Q14. A backup administrator is tasked with monitoring PowerProtect DD capacity metrics. The administrator is backing up 2 TB of data daily with a reduction rate at 5x. After data reduction, subsequent full backups compress down to 100 GB.
The initial backup requires 400 GB with a 10 percent increase in the data each day. Each incremental backup is 200 GB. After data reduction, each incremental backup is 20 GB.
What is the weekly burn rate (GB) after six daily incremental backups and one weekly backup?

Q15. Following best practices for a PowerProtect DD CIFS environment, what is the recommended SESSTIMEOUT value in seconds?

Q16. How can remote logging with a syslog server be configured on a PowerProtect DD system?

Q17. A backup administrator has enabled the Retention Lock feature on their PowerProtect DD appliance. Over time, the administrator noticed an increase in file system utilization. Upon further investigation, the administrator discovered expired files are still present on the appliance.
What is the most likely reason for this issue?

Q18. What is a characteristic of using replication with Dell EMC Cloud Tier?

Q19. What information does the daily Autosupport report contain?

Q20. Which component of PowerProtect DD is Data Invulnerability Architecture a feature of?

Q21. What is the maximum capacity for a DDVE?

Q22. A backup administrator wants to verify that quotas have been enabled on a PowerProtect DD appliance.
Which command is used to verify that quotas are being enforced?

Q23. When using the DD VTL Tape Out to Cloud feature, which status will a tape show once it is in the cloud tier vault?

Q24. Which command is used to check if NFS is enabled?

Q25. A backup administrator is tasked with verifying the compression savings of a PowerProtect DD9900.
Which compression algorithm will they see enabled by default?

Q26. Where is the DD System Manager can the status of chassis components be found?

Q27. A customer needs a backup system to protect 100 TB of mission-critical data.
What should be used to back up the system?

Q28. Which PowerProtect DD technology provides fast and efficient deduplication while minimizing disk access?

Q29. How many hops should the fabric configuration be limited to when implementing the DD VTL?

Q30. An administrator monitors the performance statistics of a PowerProtect DD appliance. Low disk-write rates are shown, and the network inbound traffic is high.
What is the most likely cause of this behavior?

Q31. A backup administrator needs to implement BoostFS for Windows.
What do they need to install on the Windows server? (Choose all that apply.)

Q32. How many hops should the fabric configuration be limited to when implementing the DD VTL?

Q33. What is the maximum capacity that a cloud unit can have with DD9900?

Q34. What is a requirement to use the PowerProtect DD HA feature?

Q35. What is a main advantage of using DD Boost instead of CIFS or NFS for a backup?