Latest H12-831_V1.0-ENU Study Guides 2024 – With Test Engine PDF [Q130-Q152]

NO.130 esigth uses different colors to distinguish different alarm levels, red represents emergency, orange represents important, and yellow represents The table is secondary, and blue represents the prompt. Which of the following statements about different alarm levels is correct: (multiple choice)

NO.131 Which of the following is not part of the preparatory work for the cutover plan?

NO.132 Regarding BGP/MPLS IPVPN data forwarding, which of the following description is wrong?

NO.133 Regarding multi-instance CE (Mlulti-VPN-Instance CE, MCE), which of the following descriptions is wrong?

NO.134 Which description is correct about the MPLS forwarding mechanism? (Multiple choice)

NO.135 As shown below:

NO.136 Which of the following regular expressions can only match BGP routing entries that pass through AS200 and then AS300?

NO.137 Which of the following statements about MUX VLAN are correct? (Multiple choice)

NO.138 Network administrator A wants to use ACL to match specific routing entries. Which of the following routing entries will be matched by the ACL rules in the figure? (Multiple choice) acl number 2000 rule 10 permit source 10.0.0.0 0.0.6.0

NO.139 As shown in the figure, OSPF is deployed in a campus, and Area 1 is deployed as an NSSA area. By default, R2 will automatically generate a Type 7 LSA default route and flood it in the NSSA area.

NO.140 When OSPFv2 evolves to OSPFv3, the format and function of LSA are exactly the same, except that the network layer address in LSA changes from IPv4 to IPv6.

NO.141 The link state value information between different ISIS processes of multiple routers is considered to be isolated.

NO.142 Ethernet is a network that supports broadcasting, and once there is a loop in the network, this simple broadcasting mechanism can cause catastrophic consequences. Which of the following phenomena may be caused by loops

NO.143 As shown in the figure, network administrator A on the R1 router, after modifying the Local Preference value of the routing entry sent to R2 through the routing policy, can control the path of traffic leaving AS100.

NO.144 What check items can be set in IPSG? (Multiple choice)

NO.145 Which of the following tools cannot be used to match BGP routing entries?

NO.146 OSPF is deployed in a campus to achieve network interworking, and OSPF is also enabled on the GEO/0/2 interface of R3. Area1 is deployed as an NSSA area, and the device addresses are shown in the figure. An engineer configures a static route on R3 to access the loopback interface address of R4, and imports the static route in the 0SPF process. At this point, in the Type5 LSA received by R1, the forwarding address (FA) is____. (Note: Please fill in the IP address without mask)

NO.147 After executing reset isis all, the IS-Is protocol process needs to be restarted and neighbors need to be re-established, and various IS-IS statistics will not be cleared.

NO.148 What check items can be set by IPSG?

NO.149 Regarding the difference between NSR and NSF, which one is correct?

NO.150 After the cutover is completeD. it is generally necessary to check the following items?

NO.151 According to this picture, what can we judge? (Multiple choice)

NO.152 IGP converges faster than BGP, which may cause network traffic loss. By enabling the OSPF and BGP linkage feature of the device, the device remains as a () router within the set linkage time, so that the link metric value in the advertised LSA is the maximum value, thereby telling other OSPF devices not to use this router to forward data, so as to avoid the loss of traffic. (Note: If English letters are involved, all capitals are required)