NEW QUESTION 50
Remotely monitoring system health of a deployed conference room and rebooting it when faulty is an example of

NEW QUESTION 51
A customer wants to reuse existing network cabling to extend audio and video signals in a system refresh.
What is the PRIMARY concern?

NEW QUESTION 52
Noting the position of ventilation ducts is useful when determining

NEW QUESTION 53
For a design-bid (tender)-build project, the final step for determining the owner’s costs for an AV system is

NEW QUESTION 54
Given this system information:

What is the MINIMUM current requirement (assuming 110VAC electrical supply)?

NEW QUESTION 55
Which kind of drawing should a technician refer to in order to determine how to hang a loudspeaker line array?

NEW QUESTION 56
When is the optimal time to conduct training of end users in a new AV installation?

NEW QUESTION 57
One MAIN benefit of multicast over unicast in a network AV solution is it

NEW QUESTION 58
When considering the security of AV equipment residing on the client network, what is the MOST important step to take to keep the equipment safe from hackers before connecting the equipment to the network?

NEW QUESTION 59
During an initial customer visit, it is important to determine whether or not one is

NEW QUESTION 60
A task cannot begin before another task is completed. How is this described in a project task schedule?

NEW QUESTION 61
Which of the following protocol allows sources and displays to communicate in order to ensure the display is sent the correct signal?

NEW QUESTION 62
In order to run three cables inside a conduit, what is the maximum percentage of a conduit’s internal cross- sectional area to be considered?

NEW QUESTION 63
When doing a site survey, it is MOST IMPORTANT to consider the client’s

NEW QUESTION 64
A loudspeaker with sensitivity 90 dB SPL measured at 1 meter, 1 watt Is placed 2 meters away from a listener.
At 1 watt, what Is the SPL at the listener?

NEW QUESTION 65
In which of the following scenarios would infrared (IR) wireless microphones be preferred?

NEW QUESTION 66
The amount of light emitted through a projection system lens is TYPICALLY specified and measured

NEW QUESTION 67
The owner is looking for an audio solution for staff meetings. Which question is MOST important to ask to ensure a functioning system?

NEW QUESTION 68
A client requests for a project to be completed earlier than initially scheduled. What should the AV contractor do FIRST to address this change?

NEW QUESTION 69
Assuming a 10′ (3 m) ceiling, what is the approximate volume of this room?

NEW QUESTION 70
Which section of the Ohm’s Law chart should be used to calculate values expressed in Ohms? Select the answer by clicking anywhere within the correct quadrant.

NEW QUESTION 71
In an audiovisual system where a touch panel is to be connected to the control system via the LAN, the designer may choose to use a

NEW QUESTION 72
During the needs analysis stage, it is MOST IMPORTANT to determine the client’s