Free HP HPE6-A69 Study Guides Exam Questions & Answer [Q21-Q35]

Rate this post

Free HP HPE6-A69 Study Guides Exam Questions and Answer

HPE6-A69 Exam Dumps, HPE6-A69 Practice Test Questions

NO.21 You have removed a member out of the ArubaOS-CX 6300 VSF configuration. The login to the removed member falls. What is true about switch login recovery?

The task requires physical access to the switch

The zeroize task executes the zeroize.txt from the root of the CF card on the switch

The zeroize task will remove all user passwords: the configuration remains on the switch

The task can be executed remotely

NO.22 Match the BGP path selection criteria attributes (Each option may be used once, more than once, or not at all)

NO.23 You are working with a customer whos has a paw of Aruba 8325 switches configured for Multi-Chassis Link Aggregation The customer is complaining that users are experiencing intermittent packet drops. Which action should be taken to quickly aid you in identifying the cause?

Enable debug of vri with “console” set as the destination

Setup a mirror session to generate a Tshark file.

Setup a mirror session to niter packets for TCPDUMP analysis

Check the configured VLANs using “show vsx config-consistency”

NO.24 Which statement is true regarding remote mirroring?

The same source/destination address can be used in multiple sessions.

Per session multiple destination addresses can be configured

The ArubaOS-CX switch supports a maximum of two mirroring sessions

When mirroring destination is tunnel, a DSCP value can be set on the tunnel

NO.25 Match the repotted status to the Aruba 8325 issue (Each option may Be used once more than once, or not at all)

NO.26 The customer has a requirement for creating security filtering for IPv4 and IPv6 traffic passing through an ArubaOS-CX 6400 switch. Which statement Is true about access-list on the selected switch model?

IPv4 and IPv6 entries can be used in one ACL with separate rules

Separate IPv4 and IPv6 ACLs need to be created for inbound and outbound traffic

Only one inbound or outbound ACL can be bound to an interface.

Routed interfaces can have only inbound ACLs

NO.27 Refer to the exhibit.

Aruba CX 6300 switch has routes in three different VRFs as per the example above. The user needs to leak routes between VRF Secure and VRF Dev. and also between VRF default and VRF Dev The customer Is not able to establish routing between directly connected networks 10.100.50.0/24 and
10.102.26.0/24 Which statement is true regarding the routing troubleshooting?

Multi-protocol BGP routing needs to be defined for route leaking

Route Distinguisher needs to be set to 1 for default VRF.

Route leaking is supported between non-default VRFs only

Route leaking between default and non-default VRFs is supported with Aruba CX 8400.

NO.28 You have designed a new wired solution for a customer that uses gateways and Dynamic Segmentation Which statements about User-Based Tunneling are true? (Select two)

In U8T, the switch performs user authentication.

in UBT, the Aruba Gateway performs user authentication

UBT is supported only with Aruba Gateway standalone

in UBT, the switch sends user role Information to Aruba Gateway

In UBT, the Aruba Gateway assigns the Primary user role

NO.29 When applying me following access-Iist to an ArubaOS-CX 6300 switch:

How does this ACL behave on the selected switch? (Select two.)

The mp traffic to MANAGEMENT-SERVERS group is logged to me event logs

The tftp traffic to MANAGEMENT-SERVERS group is not logged to the event logs.

The snmp-trap traffic to MANAGEMENT-SERVERS is logged to the event togs.

The denied tcp traffic to the MANAGEMENT-SERVERS group is logged to event logs.

The denied tcp traffic to the MANAGEMENT-SERVERS group is not logged to event logs

NO.30 The customer is already using Aruba Gateway and third-party L2 switches New ArubaOS CX 6300 switches have been deployed for R&D. which have a requirement for user profiling and tunneled traffic between ArubaOS CX 6300 and Aruba Gateway What is required for this configuration to apply QoS user-based rules for the R&D client traffic?

Apply a QoS rule to the ArubaCX 6300 client port, lo classify traffic before it is tunneled.

Apply a port-access policy with QoS defined in the user role on the ArubaOS CX6300 switch

Manually prioritize IP protocol 47 traffic on the third-party switches to prioritize the tunneled traffic

Create a QoS policy for the UBT-client-VLAN traffic on the third-party switch.

NO.31 Which MAC address is valid for use as a VSX System-MAC address?

AB:00:04:00:FF:00

0A:00:00.00.00

FF:00:00:00:00:00

01:00:5E40:10.01

NO.32 A customer would like to utilize some ArubaOS-CX 6300M switches to perform OSPF routing.

All ports are routed, and ECMP is enabled, with other default parameters for OSPF. What will be the result of traffic sent from CLIENT-A to CUENT-B?

Traffic will be SW3 -> SW-4 -> SW-2.

Traffic win be SW3 -> SW-1 -> sw-2.

Traffic will be SW3 -> SW-1 -> sw-4 -> SW-2

Traffic will be SW3 -> SW-1 -> Sw-2 & SW3 -> SW-4 -> SW-2

NO.33 When an ArubaOS-CX switch uses the temporary copy of the coring state database, how does NetEdit validate if the configuration is correct?

Semantic validation

Syntax validation

Deploy validation

Planned validation

NO.34 Refer to the exhibit.

* For all traffic within VLAN 10. a remark action or DSCP value EF must be set
* For all traffic exiting VLAN 10, a remark action of DSCP value AF41 must be set Which is the correct configuration?
A)

B)

C)

D)

Option A

Option B

Option C

Option D

NO.35 The customer is implementing new ArubaOS-CX 6300 switches into an environment that has third-party switches and uses centralized authentication from Microsoft Active Directory and TACACS* servers What would be a valid configuration requirement for ArubaOS-CX switches for centralized user authentication?

Importing a TACACS server certificate for TLS authentication into the switch

Defining a TACACS server group for authentication in the switch configuration

Enabling the active directory VSA in the switch for radius authentication

Using a PAM extension for LDAP authentication with Active Directory Server.

Loading …

HP HPE6-A69 Exam Syllabus Topics:

Topic	Details
Topic 1	Given a multi-site, multi-vendor scenario, explain how to implement an appropriate Layer 3 solution Given a scenario with multiple identified network issues, resolve the issues
Topic 2	Given a multi-site, multi-vendor scenario, explain how to implement security Troubleshoot the wired network solution
Topic 3	Given a network design, apply appropriate NAE agents and apply to appropriate interfaces Plan the wired network solution
Topic 4	Identify the appropriate use of configuration methods Manage and monitor Aruba solutions
Topic 5	Given a multi-site, multi-vendor scenario, explain how to implement Aruba solution integration Given a scenario with multiple network issues, identify the causes
Topic 6	Given a network security issue, explain the methodology to use for analyzing the issues Install and configure the wired network solution
Topic 7	Given a multi-site, multi-vendor scenario, explain how to implement an appropriate QoS solution Given a multi-site, multi-vendor scenario, explain how to implement Layer 2 switching

Latest HPE6-A69 Actual Free Exam Questions Updated 60 Questions: https://www.dumpleader.com/HPE6-A69_exam.html

HP HPE6-A69 Exam Syllabus Topics:

Leave a Reply Cancel reply