[Q399-Q418] Mar-2023 Realistic H12-811_V1.0 Accurate & Verified Answers As Experienced in the Actual Test!

QUESTION 399
Now there are the following four network segments: 10.24.0.0/24, 10.24.1.0/24, 10.24.2.0/24, 10.24.3.0/24.
Which route can point to these four network segments at the same time?

QUESTION 400
Which of the following statements about OSPF neighbor status are correct?

QUESTION 401
All ports on the root bridge switch are designated ports. ()

QUESTION 402
About the correct description of the information as shown in the figure is.

QUESTION 403
The host uses the IP address 192.168.1.2 to access the Internet-it must go through NAT. ()

QUESTION 404
If the largest number in an ACL rule is 12, by default, the user does not specify a number when configuring a new rule, then the number assigned to the new rule by the system is? ()

QUESTION 405
The broadcast address is a special address that all the host bits in the network address are set to, and it can also be used as a host address. ()

QUESTION 406
Which of the following features does the OSPF protocol have? ()*

QUESTION 407
If a windows host is started for the first time, if it uses DHCP to obtain an IP address, what is the source IP address of the first packet sent by this host?

QUESTION 408
Which parameter is used in the spanning tree protocol for root bridge election? ()

QUESTION 409
To ensure that the same data stream is forwarded on the same physical link, which load sharing method does Eth Trunk use?

QUESTION 410
The output information of a certain router is shown in the figure. Which of the following statements is correct?

QUESTION 411
If the network address of a network is 10.1.1.0/30, what is its broadcast address? ()

QUESTION 412
By default, in the SNMP protocol, which port number does the agent process use to send alarm messages to the NMS?

QUESTION 413
Which devices are generally involved in wlan deployment schemes in enterprise scenarios? ()*

QUESTION 414
When using the ping command on the VRP platform, if you need to specify an IP address as the source address of the echo request message, which of the following parameters should be used?

QUESTION 415
How to enter the view of OSPF area 0 in the VRP operating system?

QUESTION 416
By default, what is the forward delay time of the STP protocol in seconds?

QUESTION 417
Which of the following IPv4 addresses the host uses cannot directly access the Internet? ()

QUESTION 418
The network as shown in the figure. Which of the following configurations can realize that Host A cannot access the HTTP service of Host B.
Host B cannot access the FTP service of Host A? () (Multiple Choice Questions)