Provide EMC DES-4122 Practice Test Engine for Preparation [Q24-Q46]

QUESTION 24
A technician needs to change the iDRAC password on a Dell EMC PowerEdge 14G server in a lights-out datacenter. The be rebooted because it is in production. The iDRAC is configured with the default credentials How could the technician change the iDRAC password?

QUESTION 25
Which card connects to the PCI bus, is physically smaller than a on the system board of a Dell EMC PowerEdge 14G server?

QUESTION 26
How can a technician know whether IDRAC9 System Lockdown mode is enabled?

QUESTION 27
You are Investigating a disk error on a Dell EMC PowerEdge server and discover a Hot Spare has not been assigned to the Virtual Disk Group. Use the simulator to assign the Global Hot Spare. When you have finished using the simulator, dick Next.

QUESTION 28
Match each RAID level to its characteristic.

QUESTION 29
An engineer needs to install an additional PSU on an existing, single PSU Dell EMC PowerEdge R740. They complete the initial installation and cabling procedures. They connect an AC cable and the power distribution unit produces normal AC output. The engineer checks power management and sees that the new PSU is in the Failed state.
What task should be completed to troubleshoot this issue?

QUESTION 30
An engineer is checking a newly delivered Dell EMC PowerEdge R640 server that will be deployed for a new database environment The inventory consists of:

The server power configuration will be set for gnd redundancy The management switch is 1000 Base-T and the top of rack switches 10Gb What additional component(s) is needed for this configuration?

QUESTION 31
You are creating a new RAID 5 storage pool on a Dell EMC PowerEdge server based on 30 x 1TB drives Which PERC model best supports this configuration?

QUESTION 32
Which rear disk drive option is available in a Dell EMC PowerEdge R740xd server?

QUESTION 33
What is required to use the iSM Automatic System Recovery feature?

QUESTION 34
After completing a disk rebuild operation, a technician needs to configure the system so that the rebuild process happens faster the expense of slowing users down.
Which setting should be changed?

QUESTION 35
An engineer wants to fully leverage Microsoft Windows Server 2016 for TPM-based guarded host deployment of a 14G server Which BIOS settings need to be used for installing the Windows server?
A)

B)


D)

QUESTION 36
An engineer is checking a newly delivered Dell EMC PowerEdge R640 server that will be deployed for a new database environment The inventory consists of:

The server power configuration will be set for gnd redundancy The management switch is 1000 Base-T and the top of rack switches 10Gb What additional component(s) is needed for this configuration?

QUESTION 37
Which mobile devices are supported by Quick Sync 2.0 in 14G PowerEdge servers?

QUESTION 38
What is a key feature introduced in OpenManage Mobile v2.0?

QUESTION 39
What is a valid password option available from the iDRAC9 Unique ID feature?

QUESTION 40
A Dell EMC PowerEdge server has been updated with an LCC and iDRAC DUP to the latest firmware when performing a firmware rollback?

QUESTION 41
A technician needs to change the iDRAC password on a Dell EMC PowerEdge 14G server in a lights-out datacenter. The be rebooted because it is in production. The iDRAC is configured with the default credentials How could the technician change the iDRAC password?

QUESTION 42
What is the Open Compute Project (OCP) card used for in a Dell EMC PowerEdge server?

QUESTION 43
What is the drive characteristic of a BOSS M.2 drive in a Dell EMC PowerEdge server?

QUESTION 44
A company that has very specific firmware requirements has acquired Dell EMC PowerEdge servers Any replaced parts of the type must match the original parts identically. The procedure must be as simple as possible with minimal risk.
What action should a technician take to help accomplish this goal?

QUESTION 45
What is the drive characteristic of a BOSS M.2 drive in a Dell EMC PowerEdge server?

QUESTION 46
Starting from which Dell EMC PowerEdge server hardware generation is the Micro SD card in the IDSDM/vFlash module supported?