2026 Dumpleader NETA NETA_2 Dumps and Exam Test Engine [Q45-Q64]

NEW QUESTION 45
Each switchboard used asservice equipmentmust be provided with amain bonding jumper.

NEW QUESTION 46
A series circuit contains two resistors. One resistor dissipates 10 W and the other dissipates 15 W. What is the total power dissipation?

NEW QUESTION 47
A piece of wire that is0.001 inchesin diameter and12 incheslong is defined as onemil-foot.

NEW QUESTION 48
Polarization Index (PI) is defined as the ratio of insulation resistance measured at:

NEW QUESTION 49
For aDielectric Absorption Ratio (DAR)test on a transformer, the 1-minute insulation resistance value is divided by the value obtained at:

NEW QUESTION 50
ASTM D 924 is a required acceptance test for liquid-filled transformers containing natural ester insulating fluid according to NETA standards.

NEW QUESTION 51
During avacuum circuit breaker bottle integrity test, which hazardous energy may be produced?

NEW QUESTION 52
Which portion of a three-phase system carries current through the windings of a transformer or motor?

NEW QUESTION 53
A 120 VAC, 60 Hz circuit supplies a 10 A load at a20° lagging power factor. What is thetrue power?

NEW QUESTION 54
A ground conductor is routed through azero-sequence current transformer (CT)together with the phase conductors feeding the load. What is the most likely result?

NEW QUESTION 55
Under what condition istagout without lockoutpermitted according to OSHA and NETA safety practices?

NEW QUESTION 56
The three-phase connection in whichone end of each winding is connected togetheris called which configuration?

NEW QUESTION 57
When making a resistance measurement, which ohmmeter range should be selectedinitially?

NEW QUESTION 58
Class 00 rubber insulating gloves are proof-tested at2,500 VAC. What color label would you expect to find on these gloves?

NEW QUESTION 59
Transformer oil samples drawn when the oil temperature isbelow 32°F (0°C)may:

NEW QUESTION 60
A 120 VDC circuit draws0.83 amperes. How much power is consumed?

NEW QUESTION 61
When measuring voltage using a multirange voltmeter, which range should be selectedfirst?

NEW QUESTION 62
A1500:5 multi-ratio CTproduces400 Vat the1200:5 tapduring saturation testing. What voltage is expected at the1500:5 tap?

NEW QUESTION 63
How many connection points are typically found on a Kelvin bridge used for low-resistance measurements?

NEW QUESTION 64
Which ANSI device number corresponds to anundervoltage relay?