[Q43-Q60] The Best Valid F5CAB5 Dumps for Helping Passing F5CAB5 Exam!

QUESTION 43
Plaintext
warning tmm[<pid>]: 011e0002:4: sweeper_segment_cb_any: Aggressive mode /Common/default-eviction- policy activated (0) (global memory). (345209/690176 pages) warning tmm[<pid>]: 011e0003:4: Aggressive mode sweeper: /Common/default-eviction-policy (0) (global memory) 1 Connections killed What is happening when the BIG-IP Administrator sees the messages in the LTM log displayed above? (Pick the 2 correct responses below)

QUESTION 44
Refer to the exhibit.

The image shows the status of a virtual server namedapplication_vsin the BIG-IP Configuration Utility.
What is the cause of the status shown? (Choose two answers)

QUESTION 45
In an F5 BIG-IP system, a pool is configured with a health monitor and the “ManualResume” feature is Enabled. If a poolmember is marked Offline(Red) due to a health monitor failure, what will be the status of the member once the health monitor successfully passes again?

QUESTION 46
Which two methods should the BIG-IP Administrator troubleshoot a Pool-member that’s been marked
“DOWN” by its Health Monitor? (Pick the 2 correct responses below)

QUESTION 47
Refer to the exhibit.

A BIG-IP Administrator configured a virtual server with a pool of 3 members and selected the Round Robin load balancing method to evenly distribute traffic across the pool members. During initial testing, traffic was not evenly distributed and the pool member 172.16.20.3 received more traffic than the other pool members.
Refer to the exhibit and the virtual server configuration provided below:
Plaintext
ltm virtual http.vs {
destination 10.10.1.100:http
ip-protocol tcp
mask 255.255.255.255
persist {
source_addr { default yes }
}
pool http.pool
profiles {
tcp{}
}
serverssl-use-sni disabled
source 0.0.0.0/0
source-address-translation {
type automap
}
translate-address enabled
}
What is the most likely cause of this behavior?

QUESTION 48
The BIG-IP Administrator is investigating disk utilization on the BIG-IP device. (Exhibit shows /dev/md4 mounted on / at 100% utilization). What should the BIG-IP Administrator check next?

QUESTION 49
A BIG-IP Administrator observes the following pool member status message:
Pool /Common/testpool member /Common/10.120.0.5:8090 monitor status down
[/Common/http: up, /Common/http2: down; last error:]
Why is this pool member being marked down? (Choose one answer)

QUESTION 50
Due to a change in application requirements, a BIG-IP Administrator needs to modify the configuration of a Virtual Server to include a Fallback Persistence Profile. Which persistence profile type should the BIG-IP Administrator use for this purpose?

QUESTION 51
A BIG-IP Administrator suspects that one of the BIG-IP device power supplies is experiencing power outages. Which log file should the BIG-IP Administrator check to verify the suspicion?

QUESTION 52
A traffic group includes four devices. The failover method is HA order. The failover order is:
– BIGIP-D
– BIGIP-B
– BIGIP-C
– BIGIP-A
Auto fallback is enabled. BIGIP-D has been forced to standby. BIGIP-B was active before being rebooted. Which device is active when BIGIP-B is up after the reboot?

QUESTION 53
During a high-demand traffic event, the BIG-IP Administrator needs to limit the number of new connections per second allowed to a Virtual Server. What should the administrator apply to accomplish this task?

QUESTION 54
The BIG-IP Administrator is investigating disk utilization on the BIG-IP device. (Exhibit shows
/dev/md4 mounted on / at 100% utilization). What should the BIG-IP Administrator check next?

QUESTION 55
A BIG-IP Administrator suspects that one of the BIG-IP device power supplies is experiencing power outages. Which log file should the BIG-IP Administrator check to verify the suspicion?
(Choose one answer)

QUESTION 56
A gateway_icmp health monitor is configured on a pool. The BIG-IP Administrator is investigating why the pool is reported as down while the server is online. Other pools with servers in the same subnet are correctly monitored.
What can cause this behavior? (Choose one answer)

QUESTION 57
A BIG-IP Administrator needs to collect HTTP status code and HTTP method for traffic flowing through a virtual server.
Which default profile provides this information? (Choose one answer)

QUESTION 58
Which tmsh command shows virtual server status?

QUESTION 59
Which menu should you use on the BIG-IP Configuration Utility to generate a QKView support file? (Choose one answer)

QUESTION 60
Which command displays ARP table entries?